4/14/2023 0 Comments Vinylium dubplate cutterthe vinylium dubplate cutter is available right now. vinylium normally manufacture and services products in the pro audio segement.nearly all big cutting rooms use the vinylium service and technique. Available in either clear or classic black, all of our hand cut Dubplates come with a blank white label, anti-static & cardboard sleeves and the vinyl mastering is included too We do CD size records, which are great for promos. the source is a cd and going straight into the cutting amplifier. The electronics may be expensive and complicated too. the vinylium dubplatecutter was developped by profis in the topic of disc cutting equipment. Our custom made vinyl Dubplates are professionally cut onto heavyweight 'Everlasting Vinyl'. cutting vinylik blanks on a vinylium dubplate cutter. (like modified technics 1200) and even then you have little hope of approaching the quality of a real disc mastering lathe! look at for a pre-built alternative - but only if you have $$$ thousands to spare! If you know someone who has the real deal (neumann or scully disc mastering lathe) and will cut dubplates for a reasonable price, then that route would be better! (no-one near me does that!) And quite a lot of machining (or sneaky fitters tricks!) will be required. Vinylium does ONLY guarantee lacquer cuts performed by Vinyl Room cutting studio Holland. There is a new upload box on the product pages that should hopefully fix our previous problems. Please contact us at platterrecords-at-hotmail-dot-com. And cutting stylus are very expensive, around 120euro for a re-conditioned one. Custom made one off vinyl records and dubplate cutting services. Vinylium Dubplate Cutting deck unit, cutting head, control unit, a set of 12’’ dub plates, a ruby cutting stylus, a diamond cutting stylus, overhead heating lamp and full training. In the last 2 weeks, I have found more info on this topic than the first few months of searching!Īfter looking at the specs of the vestax vinyl cutter, I thought that it couldn't be too hard to match that performance! (only 12kHz freq response! :o)īut then I saw how much a 'real' cutting lathe and electronics was! aaarrrgggghhh!Īnd then I looked at how expensive it was to have dubplates made, so I thought I would at least have a go at diy.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |